NEXTSTEP Fast SCSI-2 Disks

From Higher Intellect Wiki
Jump to: navigation, search

NEXTSTEP

Title: Fast SCSI-2 Disks

Entry Number: 1679
Last Updated: 12, August 1994
Document Revision: 894A

Keywords:  Fast, SCSI, SCSI-2, Synchronous, Drivers

Question

Does NEXTSTEP support SCSI-2 or Fast SCSI?  

Do the NEXTSTEP SCSI drivers support sync transfer mode?

Answer

"Fast SCSI" takes synchronous SCSI and reduces some timing to speed up data transfers and make them "fast".  The m68k driver does not support synchronous SCSI, or Fast sync.

Fast SCSI may be used on NS/FIP hardware depending on the host adapter and the SCSI device used. Some of the intelligent host adapters have hardware and firmware support for Fast SCSI -- support of the feature is totally transparent to the driver software. 

Here's a table of currently supported SCSI adapters:

Adapter		Sync	Fast Sync

NeXT m68k	No	No

Adaptec 154xB	Possible 	No
Adaptec 154xC	Possible	No
Adaptec 154xCF	Possible	Possible
Adaptec 6x60	Possible	Don't know
Adaptec 274x	Possible	Possible
DPT 2xxx	Possible	Possible
BusLogic 542	Possible	Don't know
BusLogic 747	Possible	Possible
BusLogic 455	Possible	Possible

HP712		Yes (default)	No


"Possible" means the feature can be supported if:
1) it's enabled and
2) the device on the other end of the bus supports it.

Note that synchronous fast synchronous options should be disabled as the default.  They should only be enabled after you're sure everything works with them disabled. If asynchronous SCSI doesn't work, synchronous and Fast SCSI aren't going to work. The DPT adaptors will automatically negotiate and set both synchronous and Fast SCSI options with each device on the bus, using the SCSI message protocol.

SCSI-2 does not imply Fast SCSI or even sync SCSI.  Sync and Fast Sync are optional and not required for conformance to the SCSI or SCSI-2 standards.

Fast SCSI transfer rates can go up to 10 MB/s on a narrow (8-bit vs wide 16-bit) bus. This does not mean that the disk subsystem throughput will be that high.  The 10 MB/s (or whatever) transfer rate means only that when the disk has data ready, it can transfer it across the bus at 10 MB/s.  Throughput is greatly affected by how fast a disk can get data off the media and the firmware's overhead for processing a command.


Share your opinion