The above line assumes you have installed the software in C:\ULTRAPNP. Make changes to match your drive \ directory if necessary.
The above line assumes you have installed the software in C:\ULTRAPNP. Make changes to match your drive \ directory if necessary.
+
+
===Jumper Settings===
+
If you have the PnP, then you only have one jumper (JP9). It is to determine what mode the card is in. (By default, it is in Plug & Play Mode. If the jumper is set, the card is no longer in Plug & Play mode. This means that Plug and Play BIOS's (and Win 95) will not automatically detect the card. Do not change this jumper as this function is not working yet. This will be fixed in a later release of the drivers.
+
+
If you have the PnP Pro, you also have a set of jumpers directly beside the IDE port. These jumpers tell the card the amount of memory it can address. By default, it addresses up to 4.5 megs (512k base RAM and 4 MB in SIMMs). The Jumper blocks cover 3-4, 7-8,& 9-10. ( :|:|| )
+
+
If you put on 8 MB in the SIMM slots, you must make sure that jumper 1-2 and 5-6 ONLY.. (All others are removed) ( |:|:: )